List of parts and assemblies of the rear brake caliper with technological notes on repair to drawing VC7.031:
1. Brake caliper with parking brake lever:
- replace the caliper if a leak is found in the area of the parking brake lever;
- after repairing the brake caliper, pre-bleed it.
2. Protective cap.
3. bleed valve: 10 Nm:
- before tightening, lightly grease the thread with mounting paste G 052 150 A2.
4. Self-locking bolt: 35 Nm:
- when removing and installing, it is necessary to fix the guides from scrolling.
5. Guide:
- lubricate before installing the protective cap.
6. Sealing collar:
- put on the guide and fixed in the bracket.
7. Bracket with guides and sealing cuffs:
- in fig. brake mechanisms are shown C II 41;
- it is delivered in lubrication assembly with guides as a single spare part;
- in case of damage to the sealing collars or guides, install a repair kit. When installing the rails, use the supplied tube of grease.
8. Sealing collar:
- is put on the outer edge of the piston.
9. Piston with automatic position adjustment:
- preliminarily apply a little mounting paste G 052150 A2 to the piston.
10. O-ring.
Visitor comments