Use only alcohol to clean the brakes.
Apply a thin layer of assembly paste G 052 150 A2 to the bore walls of the brake cylinders, pistons and seals.
List of parts and assemblies with notes on installation work to Figure VC7.022:
1. Protective cap:
- put on the bleeder fitting.
2. Bleeding port: 10 Nm:
- before tightening, lightly grease the thread with mounting paste G 052150 A2.
3. Caps:
- is inserted into the support sleeve.
4. Guide: 30 Nm.
5. Support sleeve:
- insert into the brake caliper.
6. Brake caliper.
7. Bracket to which the brake caliper is attached.
8. Support spring:
- is inserted with both ends into the holes of the brake caliper.
9. O-ring.
10. Piston:
- preliminarily apply a little assembly paste G 052 150 A2 to the piston.
11. Sealing collar:
- do not damage when installing the piston.
Visitor comments