Contents: Removal ↓ Installation ↓
Removal
1. Press the piston out of the brake caliper with compressed air.
To prevent damage to the piston, install a wooden stop.
2. Remove the sealing ring using the mounting wedge (1).
When removing, do not damage the cylinder surface.
Installation
Before installation, apply a thin layer of G 052150 A2 assembly grease to the piston and sealing ring.
1. Insert the sealing ring into the cylinder.
2. Place the sealing cuff with the outer edge on the piston.
3. Insert the inner edge of the cuff into the groove of the cylinder using a wedge (1).
The piston is positioned in front of the caliper.
4. Press the piston into the caliper using the tool.
The outer edge of the sealing cuff will then enter the piston groove.
The original can be viewed on the portal: VWmanual.ru
Visitor comments