Contents: Removal ↓ Installation ↓
Note: Only for vehicles with DSG gearbox
Note: For vehicles with DSG gearbox, the needle bearing must be installed at the rear of the crankshaft.
Removal
Fig. 2.282. Removing the bearing
Remove the bearing using a standard puller, such as a Kukko adapter (fig. 2.282).
Installation
Fig. 2.283. Pressing in the bearing
Press the bearing in using a mandrel or centering mandrel (fig. 2.283).
Fig. 2.284. Planting depth
The planting depth A should not exceed 2 mm (fig. 2.284).
Note: The marking on the needle bearing side must be readable in the installed position.
Visitor comments