Contents: Removal ↓ Installation ↓
Removal
Insert hook T20143/2, as shown in Figure 2.45, under the working edge of the seal. Rest the hook on the flange, pry the seal in the direction of the arrow and remove it.
Installation
Pull the seal A with the outer side through the sleeve T10122/ 1 onto the sleeve 10122/ 2 (Fig. 2.46).
Disconnect the mounting bushings.
Then fit the T10122/2 tightening sleeve with a dry seal onto the crankshaft journal.
[The original can be viewed on the portal www.VWmanual.ru]
Press the seal using the T10122/3 mandrel until it stops against the flange (Fig. 2.47).
Visitor comments