If the vehicle is equipped with headlights with gas discharge lamps, it is advisable to remove the headlight before removing the headlight corrector actuator motor.
Execution order
1. Remove the protective cap from the rear of the high beam headlight.
2. Disconnect the electrical connector from the headlight range control actuator motor.
3. To release the headlight corrector actuator motor on the left headlight from its retainer, turn it counterclockwise.
4. To release the headlight corrector actuator motor on the right headlight from its retainer, turn it clockwise.
5. Remove the headlight corrector actuator motor, while moving it to the side, remove the spherical head of the corrector pusher from the clamp on the headlight reflector. The process of removing the headlight corrector from the clamp on the reflector can be observed after removing the high beam lamp.
6. Lock the reflector from turning through the high beam bulb installation hole and insert the spherical head of the headlight corrector pusher into the clamp on the reflector.
The original can be viewed on the portal: www.VWManual.ru
7. Turn in the direction opposite to removal and secure the headlight range control actuator motor.
8. Connect the electrical connector to the headlight range control actuator motor.
Visitor comments