The location of the interior lighting bulbs in the car
- 1 - glove box lighting lamp,
- 2 - front interior lighting and reading lamp,
- 3 - front lights for interior lighting,
- 4 - rear lights for interior lighting,
- 5 - lamp for lighting the luggage compartment,
- 6 - interior lighting reflector,
- 7 - entrance lights,
- 8 - the switch of a control lamp of a manual brake
Front Dome Light and Reading Light Bulb
1. Remove diffuser. To do this, insert a knife blade or other similar object into the gap between the housing and the diffuser (arrow) and carefully pry up the diffuser.
2. Press and in this position turn the bulb counterclockwise to remove it from the socket.
3. Install a new bulb in the socket, press and in this position turn the bulb clockwise until it locks in the socket.
4. First place the diffuser with both small locating lugs against the switch bezel, then push upward at the front until both long locating lugs lock into the holder.
Rear dome light
1. Remove the entire cover frame by inserting the flat end of a screwdriver between the cover and headlining (arrow) and carefully pry it out with a screwdriver.
2. On the reverse side, slide the plastic cover out of the way.
3. Remove the defective lamp and insert a new lamp.
4. Slide the cover on the side until it locks into place.
5. Install the frame on the connector side first and then press it into the cutout in the headlining.
Entrance lights in the door
1. Pull out the lamp holder completely. To do this, insert the flat end of a screwdriver into the recess (arrow) between the lamp and the door upholstery and then, prying off the lamp holder, lift it up until you can remove it towards the rear from the upholstery.
2. Remove the defective lamp and insert a new lamp.
3. Insert the bulb holder at the socket side first and then press it into the cutout in the door trim.
Visitor comments