Note: Due to the small size of the terminals of the cable part of the controller connector, when testing through the specified terminals, it is recommended to use a transition terminal box.
Checking the sensor signal voltage
Turn off the ignition. Disconnect the controller connector and connect the transition terminal box to the connector, connect the voltmeter to terminals "1" and "11" of the cable part of the connector (fig. 2-135). hang up the left front wheel of the car, turn on the ignition and rotate the left front wheel. In this case, the voltage value on the voltmeter should change within the range of 0-4.0 V.
Checking the sensor supply voltage
Turn off the ignition. Disconnect the vehicle speed sensor connector. Connect a voltmeter to terminals "1" and "3" of the cable part of the connector (fig. 2-134), turn on the ignition and check the voltage with a voltmeter, which should be no less than 9 V.
Visitor comments