After drilling holes in the body, the edges of the holes should be deburred, primed and varnished. Chips that inevitably form during drilling must be removed from the body without residue.
When installing additional accessories that affect the electrical wire system, in order to prevent a short circuit, it is necessary to disconnect the ground wire (-) from the battery and hang it aside.
Cables that need to be laid when installing accessories other than the cables fitted as standard in the vehicle should always be routed along the existing cable harnesses, if possible, using the already existing cable ties and rubber grommets.
If necessary, to prevent noise during the trip and avoid chafing, newly laid cables must be additionally secured with insulating tape, polymer mass, tape clamps for fastening wires, etc. At the same time, special attention must be paid to ensuring that there is a distance of at least 10 mm between the brake system pipes and the newly fixed cables, and that there is a distance of at least 25 mm between the brake system pipes and cables that swing with the engine or with other parts of the car. mm.
Before installing additional appliances that consume electricity (for example, in a residential car, as well as fog lights, telephone), you need to check if the existing alternator can handle the increased load. If necessary, the installation of a high power generator should be provided.
The following accessories are available for fixing and cushioning optional wire sets or individual cables:
Visitor comments