Contents: Removal ↓ Installation ↓
Removal
Drain the coolant from the system.
Set the engine crankshaft to the position corresponding to the TDC of the piston of the 1st cylinder.
Disconnect the wire from the negative terminal of the battery.
Loosen the generator mounting bolts and, depending on the configuration, the power steering pump, and remove the drive belts.
Remove the front timing belt covers.
Loosen the pump mounting bolts and loosen the camshaft drive belt tension.
Remove the camshaft drive belt.
Remove the pump.
Installation
Thoroughly clean the connector surfaces and install new gaskets.
Install the water pump and tighten the mounting bolts.
Install the camshaft drive belt. Make sure that the timing adjustment marks are aligned and that the belt is tensioned correctly.
Finally tighten the pump mounting bolts.
Install the front camshaft timing belt covers.
Install and adjust the tension of the alternator drive belt and, depending on the configuration, the power steering pump drive belt.
Connect the wire to the negative terminal of the battery.
Pour coolant into the expansion tank.
Start the engine and remove air locks from the cooling system, check the engine idle speed adjustment and ignition timing.
Visitor comments