Starting a cold engine
FZ and EP engines
Pull out the carburetor choke cover handle to failure. At the same time, the control lamp in the instrument cluster lights up yellow.
Turn on the starter without pressing the accelerator pedal.
A few seconds after starting the engine, move the choke cover handle to the first fixed position.
Set the vehicle in motion.
As the engine crankshaft speed increases, push the air damper cover handle of the device, first to the second, then to the third fixed position, and then drown the handle. At the same time, the control lamp in the instrument cluster goes out. As soon as the engine starts to work steadily at one of the fixed positions of the handle, immediately set it to the next position.
Engines YN, WVF YP, DT, DS
Engage the automatic carburetor starter by fully depressing and slowly releasing the accelerator pedal (at low ambient temperature, press the pedal twice).
Turn on the starter without pressing the accelerator pedal.
After the engine has warmed up, reduce the idle speed by briefly depressing the accelerator pedal several times.
Key positions in the ignition switch:
«0» - turned off. To turn on the anti-theft device, remove the key from the ignition switch, turn the steering wheel in any direction until a click is heard. It is forbidden to remove the key from the ignition switch while the car is moving;
«1» — ignition. In the instrument cluster, the indicator lamps for the battery charge, oil pressure, and, depending on the equipment, the temperature or coolant level indicator lamps light up. The key is not removed. Do not leave the key in the position for a long time «1» when the engine is not running, to avoid overheating of the ignition coil;
«2» — starter. When starting the engine, turn the key clockwise until it stops and hold it in this position, overcoming the resistance of the return spring. When the force is released, the key returns to the position «1».
If the engine does not start on the first attempt, turn off the ignition by returning the key to the «0», then turn on the starter again. If the key is turned to position «2» When the headlights are on, they automatically turn off and the parking light comes on. This also automatically turns off the windshield wipers, the heater fan and the rear window heating element, if they were turned on.
On vehicles with automatic transmission at very low ambient temperatures after starting, run the engine for approximately 1 minute at high idle before shifting into any gear. The selector lever must be in position «R» or «N «, and the parking brake is applied.
JS Engine
Thanks to the automatic dosing of the combustible mixture, both cold and hot engines are started. When starting, lightly depress the accelerator pedal and hold it in one position until the engine starts to run.
Hot engine start
FZ and EP engines
Operate the starter without pulling the carburetor choke cover handle.
If the engine does not start, turn on the starter again by lightly depressing the accelerator pedal.
Engines YN, WV, YP, DT, DS
Engage the starter by slowly depressing the accelerator pedal fully.
As soon as the engine starts, release the accelerator pedal.
JS engine
See cold start.
Starting an overheated engine
Carburetor engines
Press the accelerator pedal all the way down and, holding it in this position, turn on the starter.
As soon as the engine starts, release the accelerator pedal.
JS Engine
See cold start.
Visitor comments