Contents: Removal ↓ Installation ↓
Removal
1. Remove the ground cable from the battery.
2. Remove the driver's side airbag.
3. Remove the steering wheel.
4. Remove the two screws from the lower steering column cover and remove the upper steering column cover (1).
5. Unscrew the three screws (arrows), remove the steering column release handle (2) and remove the lower steering column cover (1).
The information is presented on the website: vwmanual
6. Remove the 5mm Allen screw (3) to release the clamp securing the steering column switches (4 – coil spring, arrows – electrical connectors).
7. Disconnect the electrical connectors from the steering column switches.
8. Please note that the coil spring remains on the steering column multifunction switch, so do not rotate the spring from the center position when removing it.
9. Remove the multifunction switches.
Installation
1. Install the switch onto the steering column, but do not tighten the switch mounting bolt at this stage.
2. Install the steering wheel.
3. By moving it, set the multifunction switch (2) to a position where the distance (a) between the steering wheel (1) and the switch is 2.5 mm (3 – switch mounting bolt).
4. Remove the steering wheel and install the lower and upper steering column covers.
5. Install the steering wheel.
6. Install the airbag into the center of the steering wheel.
7. Connect the ground wire to the battery.
Visitor comments