Replacing the generator drive shaft seal (VW Touareg 1)

Cars with engine letter designations AYH, BKW

Remove the fuel filter.

Cars with BLE and BWF engines

Remove the bypass cover from the EGR radiator.

Assembly operations for all vehicles

Remove the three-phase generator.

NOTE: When removing the oil seal, be careful not to damage the seating surface.

Carefully remove the old sealing ring using the T20143/1 puller (fig. 2.178).



[The original information is posted on the resource: www.VWmanual.ru]

Remove any remaining oil from the drive shaft of the three-phase generator using a clean cloth.

Press the inner part of the seal outward as shown in Figure 2.179.



Screw the guide sleeve T10208/1 by hand to the drive shaft of the three-phase generator and carefully install the seal A until it stops (fig. 2.180).





First install the T10208/2 stop, then press the inner part of the oil seal until it stops.

First install the T10208/3 stop, then press the outer part of the seal until it stops (fig. 2.181).



Further installation is carried out in reverse order.