Removing
Remove the front soundproofing.
Remove the lower part of the air filter of the first and second row, cylinder air filter.
Unscrew the engine mounting nuts on the left and right engine mounts.
Center the T10296 bracket guides in the cylinder block stops (pic. 2.164) in the center of the bracket. Tighten the guides.
Insert bracket T10296 into the VAG 1383A engine and gearbox rack and lightly press the bracket against the block head stops (engine and gearbox) (pic. 2.165).
After that, unscrew the right and left mounting bolts of the engine mount.
Carefully lift the engine and transmission using bracket T10296 and remove the engine mount.
ATTENTION: If necessary, use the free space between the cylinder heads and the front wall.
If necessary, unbolt the engine mounts from the cylinder head and remove the engine mounts with the engine mount.
Installation
When installing, check the correct fit of the engine mount pin in the support bracket.
Fasten all fixing bolts and nuts by hand and tighten to the specified torque.
Tightening torques
Threaded connection | Tightening torque, Nm |
Engine support to cylinder block | 50 |
Engine mount to support bracket 1 | 60 |
Engine mount to engine mount 2 | 75 |
Further installation is carried out in the reverse order.
Visitor comments