Work execution procedure
NOTE: When removing the oil seal, be careful not to damage the seating surface.
Carefully remove the old sealing ring using the T20143/2 puller (fig. 2.177).
Remove any remaining oil from the crankshaft journal using a clean rag.
Connect the mounting sleeve T10207/1 and the mounting sleeve T10207/2. Put the seal A on the mounting sleeve T10207/2 until it stops (fig. 2.175).
Disconnect the mounting bushings.
Install the T10207/2 mounting sleeve together with the oil seal onto the crankshaft sealing gasket and tighten the knurled head bolts A by hand.
Press the oil seal using the T1207/3 mounting sleeve until it stops (fig. 2.176).
Further installation is carried out in reverse order.
(View the original on the website: VWmanual.ru)
Visitor comments