Install three M12 hex nuts between the counter support and the driven disc. Installation location of the counterholder: A when loosening, B when tightening.
Installation of a slave disk
Install the driven disc using a washer.
Install new bolts and tighten to 30 Nm.
Use a vernier caliper to check the distance between the driven disk and the cylinder block (pic. 2.167). Set value A: 20.6 mm.
If the set value is not reached:
Remove the driven disc and install a wear washer between the driven disc and the crankshaft. Tighten the bolts again with a torque of 30 Nm.
Tighten the bolts to 50 Nm and make another 1/4 turn (90°), turning can be carried out in several stages.
Visitor comments