Front flange seal and vibration damper (VW Touareg 1)

Fig. 2.172. Front flange sealing gasket and torsional vibration damper:
1 - Front flange sealing gasket; 2 - bolt 8 Nm; 3 - water pump cover; 4 - torsional vibration damper; 5 - bolt 50 Nm + tighten by 1/4 turn (90°); 6 - washer; 7 - sealing ring; 8 - bolt 13 Nm

Tighten the mounting bolts in the sequence shown to a torque of 8 Nm.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Tarasov Ivan

Previous articles
Removal and installation the crankshaft support ramp
Crushing and installing the slave disk
Removal and installation of engine mounts and cushions
Removal the engine
5.0L Diesel Engine Fastening Tightening Torques
5.0L Diesel Engine Specifications

Next articles
Replacing the crankshaft oil seal on the vibration damper side
Replacing the crankshaft oil seal on the engine timing side
Replacing the generator drive shaft seal
Installing the timing cover
Removal and installation the camshaft drive gear
Checking the valve timing

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet