Photo 4B.78A. Removing the crankshaft bolt.
It is tightened very tightly, so it is necessary to block the flywheel from rotating while removing it (see photo).
Photo 48.78B. One of the methods of blocking the flywheel from rotating.
79. Remove 4 hexagon-head bolts securing the vibration damper (see photo).
Photo 48.79. Removing vibration damper bolts.
80. When installing the vibration damper in place, do not forget to place a washer under it, which should fit with the recess in the groove (see photo).
Photo 4B.80. Install the washer under the vibration damper: 1 - Washer; 2 - Notch; 3 - Undercut.
81. Tighten the crankshaft bolt to the required torque.
Visitor comments