Removing
1. Open the hood.
2. Press the jet 1. by pressing it up in the direction of arrow A, and then remove it from the seat on the back of the hood, moving in the direction of arrow B (see illustration).
3. Turn the retaining ring on the washer hose 2 and disconnect the hose from the jet (see illustration 12.2).
4. Disconnect if there is a jet heater plug.
Installation
5. Clean, if necessary, jet nozzles. To do this, wash them with water, acting in the direction opposite to the outlet of the washing liquid from the jet. Then blow out the jet with compressed air in both directions.
The jet is installed in the reverse order of removal. The jet should lock into place during installation, which is accompanied by a distinct click.
Jet adjustment
6. Adjust the direction of the washing liquid flow from the jet by turning the adjusting screw (see arrow in illustration) in height.
Attention! Turning the adjusting screw clockwise shifts the height of the jet of washing liquid downwards.
Visitor comments