Contents: Removal ↓ Installation ↓
Removal
Disconnect the ground wire from the battery and open the windshield washer reservoir.
1 - hose connection from windshield washer reservoir, 2 - hose connection to upper sprayer
A - switch; B - threaded sleeve; C - handle; D - windshield washer start button
Unscrew handle C and remove it together with the windshield washer start button.
Loosen the threaded sleeve with round-nose pliers or a screwdriver, tapping it lightly with a hammer.
Push the windshield washer switch forward, disconnect and remove the hoses and wires from the switch (having previously marked them) through the glove compartment, after removing its lid.
Installation
Connect the hoses to the switch as shown in the picture.
Caution! Do not mix up the hoses!
Connect the electrical wires to the switch according to the marks.
Install the switch and secure it with a threaded plug. Screw in the rotary handle and push the start button.
Fill the windshield washer reservoir with water.
Connect the ground wire to the battery and check the operation of the windshield washer.
Visitor comments