Contents: Removal ↓ Installation ↓
Removal
Disconnect the ground wire from the battery.
Remove the windshield wiper arms.
1 - windshield wiper lever; 2 - inner sealing ring; 3 - wiper shaft with crank
Mark and disconnect the wires from the windshield wiper motor.
Loosen the bolt (see arrow) and remove the electric motor with the support shield.
Installation
Check the sealing rings, wiper shaft gaskets and its axial play. It should not exceed 0.2 mm.
Assemble the windshield wiper shaft.
Place the washer on the axle from the outside and tighten the nut.
Install and secure the windshield wiper motor.
Connect the wires to the electric motor. Caution! Lay the wires so that they do not touch the electric motor rod.
Install and adjust the windshield wiper arms.
Connect the ground wire to the battery.
Visitor comments