Removing
1. Return the wiper blade to its original position by wetting the glass with water and letting the cleaner run for a while.
2. Remove the cover that covers the jet on the wiper arm and carefully remove the jet using needle nose pliers (see arrow in illustration).
Installation
3. Clean, if necessary, jet nozzles. To do this, wash them with water, acting in the direction opposite to the outlet of the washing liquid from the jet. Then blow out the jet with compressed air in both directions.
4. Install the jet on the mounting place, pressing it in as far as it will go. The jet should be positioned so that its nozzles are directed vertically upwards.
5. Adjust the height of the supply of washing liquid from the jet.
6. Close the jet cap.
Jet adjustment
7. Open the jet cover on the wiper brush arm.
8. Adjust the position of the jet using a needle, for example, HAZET 4850-1, inserting it into the nozzle and marking the point in the center of the glass cleaning zone where the jet of washing liquid should fall (see illustration).
9. Close the jet cover.
Visitor comments