Attention! Removal and installation of the washer reservoir for these models is carried out in the same way as like the Golf cars.
Removing
13. Turn off the ignition and remove the key from the lock.
14. Unscrew a bolt which fastens a refueling mouth of a tank.
15. Disconnect a tube from the union of a tank and take a tube together with a refueling mouth from a motor compartment.
16. Remove a forward bumper, the corresponding chapter see.
17. Set the front cross member to the service position, see the relevant chapter.
18. Unscrew the bolt (see arrow in illustration) tank attachments.
19. Disconnect the plug of the sensor 1 of the washing liquid level indicator in the tank and the plug of the washer pump 2 of the headlights (see illustration 15.18).
20. Disconnect the hoses from the washer pump and remove the pump by pushing it up and releasing it from the mount. Disconnect the pump plug as well.
21. Disconnect the washing fluid supply hoses from the tank.
22. Remove the washer reservoir from the rails.
Installation
23. Install the washer reservoir in the installation place and fix it on the rails.
Installation of dismantled parts is carried out in the reverse order of removal.
In this case, the lower protrusion on the filler neck must go into the hole on the engine mount.
Visitor comments