1, 2, 3, 4 - switch positions
The direction indicators only work when the ignition is on.
Right turn signal, switch up (1).
Left turn signal switch down (2).
When the direction indicator is on, the control lamp flashes simultaneously.
Once the vehicle has completed the curve, the turn signal will turn off automatically.
Giving a turn signal before changing lanes
The switch should only be pressed up or down until the back pressure increases and held in this position - the control lamp should flash simultaneously with the direction indicator.
High beam on/off
Inclusion
1. With the low beam on, press the switch forward (3).
2. When switching to high beam, the high beam warning lamp comes on.
3. When the high beam is on, the low beam is also on.
Shutdown
4. With the low beam on, push the switch to the rear (against arrow 3).
Light signal
Move the steering column switch to the steering wheel (4) – the control lamp of a high beam will light up.
Parking lighting
The parking lights are on only when the ignition is off.
Parking lights on the right, switch up (1).
Parking lights on the left, switch down (2).
After the key is removed from the ignition, a buzzer sounds when the driver's door is open.
Visitor comments