Contents: Turn on outdoor lighting (1) ↓ Instrument cluster illumination (2) ↓ Headlight leveling corrector (3) ↓ Emergency alarm system ↓
- 1 – turn on external lighting;
- 2 – backlight of control devices;
- 3 – headlight range adjuster
Turn on outdoor lighting (1)
- off;
- parking lights;
- low beam or high beam.
The headlights only light when the ignition is on. When the engine is started and after the ignition is turned off, they automatically switch to parking lights.
Warning: If the lights are not switched off after the key is removed from the ignition, a buzzer-type signal will sound when the driver's door is open.
- fog lights.
Pull the exterior lighting switch in the parking light or low/high beam positions to the first detent position.
When the fog lights are switched on, the corresponding green pictogram lights up.
- rear fog light.
CARS WITHOUT FOG LIGHTS
Turn the exterior lighting switch to the low/high beam position and pull it out as far as it will go.
CARS WITH FOG LIGHTS
Pull the exterior lighting switch to the parking light or low/high beam position to the second detent.
Warning: When the rear fog light is on, the indicator light on the instrument panel comes on.
Warning: Due to the high glare of the rear fog light, it should only be used in poor visibility conditions. The electrical circuit of the factory-installed trailer towing equipment is designed so that when a trailer is operated with a rear fog light, the vehicle's rear fog light is automatically turned off.
Instrument cluster illumination (2)
When the external lighting is on, the brightness of the instrument lighting is smoothly adjusted using a dial located next to the external lighting switch.
Headlight leveling corrector (3)
The electric adjustment mechanism allows for smooth adjustment of the headlight beam angle according to the vehicle load. This reduces the risk of blinding oncoming drivers. At the same time, the correct installation of the headlights provides the driver with better visibility.
The process of installing headlights can only be carried out with the low beam on.
To lower the light cone, turn the control dial downwards from its original position (-).
Emergency alarm system
The hazard warning lights also function when the ignition is off.
[View the original on this resource: VWmanual]
Turn on your hazard warning lights when, for example:
- You have reached the end of the traffic jam;
- You have been involved in a traffic accident;
- Your car has stopped due to a technical malfunction.
When the hazard warning lights are on, all the direction indicators flash simultaneously. The direction indicator lights and the indicator light in the switch also flash.
Visitor comments