Warning: Keeping your windscreen wipers in good condition is essential for good visibility.
Windscreen wipers and washers operate only when the ignition is on.
In freezing temperatures, before turning on the windshield wipers for the first time during a trip, you should check that the brushes are not frozen!
If heated windshield washer jets are present, the heating intensity is automatically adjusted from the moment the ignition is turned on, depending on the ambient air temperature.
Windshield
(The article is posted on this website: VWmanual.ru)
1, 2, 3, 4, 5 – switch positions
Windscreen wipers are off
The steering column switch is in the fixed position O.
Intermittent movement of brushes
Steering column switch in fixed position 1.
Switch A can be used to set 4 different brush operation intervals.
Switch to the right - shortened pauses between activations.
Switch to the left - extended pauses between activations.
Slow movement of brushes
Steering column switch in fixed position 2.
Fast movement of brushes
Steering column switch in fixed position 3.
Manual control of brush movement (start-stop mode)
Steering column switch in fixed position 4.
Automatic cleaning and rinsing
Lift the steering column switch towards the steering wheel (5) – the windscreen wipers and washer work.
Release the steering column switch - the windshield washer stops working, the windshield wipers continue to work for approximately 4 seconds.
Rain sensor
On vehicles with a rain sensor, when the intermittent wiper movement mode is enabled, the pause duration is automatically adjusted depending on the strength of the rain flow.
Using the regulator A in the windscreen wiper arm, you can individually adjust the sensitivity of the rain sensor.
After turning off the ignition, you need to reactivate the rain sensor. To do this, turn the windshield wipers on and off in intermittent mode.
Rear window
6, 7 – switch positions
Intermittent brush movement
Switching on: steering column switch in fixed position 6. Windscreen wiper operates every 6 seconds.
To turn off: Pull the switch back towards the steering wheel. If you do this while the wiper is moving, the wiper may continue to operate for a while.
Automatic cleaning and rinsing
To switch on: press the steering column switch fully forward 7. The windscreen wiper and washer operate as long as the switch is held in the pressed position.
Switching off: release the steering column switch. The windshield washer stops working, the windshield wiper works in intermittent mode.
Headlight Washer
When the high beam or low beam is on, each time the windshield washer is turned on, the surfaces of the headlight lenses are also washed.
At regular intervals, such as when refueling the vehicle, the surface of the headlight lenses should be cleaned of dried dirt (for example, from insects stuck to the glass).
Visitor comments