Elements for fastening glass and front door bracket
- 1 - glass seal;
- 2 - front door;
- 3 - lower inner glass seal;
- 4 - bolt, 20 Nm;
- 5 - door bracket. The window regulator is an integral part of the door bracket;
- 6 - power window motor;
- 7 - bolt, 10 Nm;
- 8 - plug;
- 9 - screw, 8 Nm;
- 10 - mechanical window regulator;
- 11 - door glass
Removing
1. Remove an internal upholstery of a door.
2. Remove process plugs (1), covering holes in the inside of the door (2 - bolt).
3. Lower glass of a door so that access to bolts of fastening of glass opened.
4. Loosen the bolt (2) and release the clips securing the glass to the power window.
5. Lifting the back of the glass and at the same time turning it, remove the glass out of the window opening of the door.
Installation
1. In the reverse order of removal, install the glass in the door and secure it to the latches. In this case, the clamps should be located at the level of the technological holes.
2. move glass (3) back, insert it into the guide and fix it with a bolt (2), tightening it with a torque of 10 Nm (1 - screw securing the door bracket, 4 - screw securing the glass retainer).
3. Install process plugs.
4. Install the interior door trim.
Visitor comments