External door opening handle and door lock
- 1 - door lock;
- 2 - lock release rod;
- 3 - supporting surface;
- 4 - support bracket;
- 5 - screw;
- 6 - external door opening handle with support;
- 7 - overlay;
- 8 - lock cylinder body;
- 9 - support;
- 10 - bolt
Removal
1. Remove the front door lock cylinder housing.
2. Release the lock (1) of the door opening handle (2) (3 – door lock control lever).
3. Move the outside door handle slightly to remove it from the door.
Differences in the rear door
1. Remove the seal (1) of the rear door in the area of the handle (2) of the rear door (3 – casing, 4 – screwdriver for unscrewing the casing mounting bolt).
2. Open the rear door handle (arrow) and hold it in this position.
3. Unscrew the bolt with a 4 mm internal shaped recess through the hole in the end of the door until it stops. This will release the casing fastening.
Warning: Do not unscrew the bolt completely, otherwise the support retaining ring will fall into the door.
4. Remove the cover (3) and the handle (2) for opening the rear door.
Installation
1. If necessary, move it to the sides to install the outer door opening handle on the door.
2. Press the door opening handle (2) to the door and, having passed the retainer (1) into the door groove, secure it to the door opening handle (3 – door lock control lever).
3. When installing the lock (1), do not move the lock control lever (3).
The original information is posted on the resource (vwmanual)
4. Install the lock cylinder housing onto the door.
Visitor comments