38. Rotate the hub and basket 90° relative to the housing, and then push it out of the housing (photo 7.18 and 7.19).
39. Remove the balls and then turn the hub perpendicular to the basket. Insert one of the projections of the hub 1 into the ball socket in the basket 2 (figure 7.4), and then roll out hub 3 from the basket.
Figure 7.4. Removing the hub from the basket
1 - hub projection; 2 - the nest of the ball in the basket; 3 - hub.
40. It is necessary to note that the hinge elements together with the balls make up a factory-selected set, and if any element is damaged, the entire hinge must be replaced (photo 7.21).
41. Clean the components in kerosene and check them for wear, similar to the outer hinge.
Visitor comments