Disconnect the negative cable from the battery.
Unscrew the bolt at the top of the starter.
Remove the axle shaft from the gearbox.
Remove the insulating sheet.
Remove the bolts at the bottom of the starter.
Disconnect the starter wires.
Turn the steering wheel to the right.
Turn the axle back and move it up.
Turn the starter drive side up and pull it down between the axle shaft and the engine
The tightening torque for threaded connections is 16 Nm.
Starter (1) disassembled: 2 lid; 3 - tie bolts; 4 - adjusting washer; 5 - safety washer; 6 - support cover.
Removal the solenoid relay
Remove the starter.
Disconnect the wire between the relay and the starter.
Unscrew the three screws on the relay flange.
Remove the relay.
View the original article on the resource vwmanual.ru

Visitor comments