Front turn signal in the model "Golf"
Unscrew both Phillips screws from the turn signal glass; remove glass.
Press the lamp a little into the socket; turn left and pull out.
When removing the turn signal housing, pull it out of the hole in the bumper and disconnect the connectors.
When assembling, make sure that the surfaces between the glass of the lamp and the housing are well sealed. If necessary, grease the sealing surfaces with additional silicone paste.
Turn signal lamp "Golf": 1 - glass of the direction indicator; 2 - fixing screws; 3 - fixing pin of the direction indicator housing.
Front turn signal in the model "Jetta"
Open the engine hood.
Remove the rubber cover at the rear of the turn signal housing.
Press the fixing bracket downwards; pull out the socket with the inserted lamp.
Press lightly on the bulb in the socket, turn to the left and remove.
When installing, the cartridge must be inserted into the body of the flashing lamp in such a way that the grooves engage with the protrusions of the body. Install the fixing bracket in the upward direction.
When dismantling the lamp housing, remove the cartridge and unscrew the 2 cross-head screws from the side of the engine compartment.
Pull out the lamp housing.
Turn signal in the model "Jetta": 1 - rubber cover; 5 - lamp holder; 6 - mounting bracket; 7 - fixing protrusions in the housing.
Visitor comments