Headlights - Golf, Jetta, Scirocco models
1. Disconnect the wire "masses" from the battery. Disconnect the wire connector and remove the headlight and parking light bulbs as described above.
2. Remove the grille (see chapter "Body and body equipment").
3. Turn out screws of fastening of the holder of a headlight and remove the holder together with a headlight.
4. Unnecessarily, the headlight should not be separated from the holder, since this will disturb the adjustment of the headlight beam direction. The headlight is attached to the holder with a twist lock - to remove the headlight, turn the lock and separate the headlight.
On Scirocco models, after removing the screws securing the holder, turn the plastic tabs on the back of the headlight inside the engine compartment and pull the headlight forward.
5. Installation of a headlight is carried out in an order, the return to removal. Check and adjust headlight beam direction (see "Vehicle maintenance work").
Front Turn Signal Lights - Golf Models
Remove the front turn signal lens as described earlier (see "Lamp replacement"). Wring out a lantern from a bumper, disconnect a plait of wires and remove a lantern from the car. Installing the lamp is carried out in the reverse order.
Models Scirocco/Jetta
Remove the lamp as described above. Turn out three screws of fastening from a back side of a lantern and remove a lantern from the car.
Rear light unit - removal
Open the tailgate or trunk lid and disconnect the connector on the back of the lamp unit. Loosen the headlight assembly screws (inside luggage compartment) and remove the lamp.
Visitor comments