Elements of fastening of the lever of a manual brake
- 1 - hand brake lever,
- 2 - nut, 25 Nm,
- 3 - compensator,
- 4 - hand brake cables,
- 5 - decorative trim of the hand brake lever
Removing
1. Remove the trim on the rear of the center console.
2. Loosen two nuts (1), that secure the base of the handbrake lever. With a screwdriver blade through the hole in the base of the handbrake lever, moving down, disconnect the handbrake cable from the lever.
3. Remove the handbrake lever.
Installation
1. Connect the handbrake cable to the compensator.
2. Screw nuts of fastening of the lever of a manual brake and tighten them the moment of 25 Nm.
3. Check and, if necessary, adjust the operation of the handbrake cables.
4. Install the center console rear trim.
Visitor comments