NOTE: Tiptronic switch-F189 is built into the harness of the two electromagnets.
Removing
Remove the selector handle.
Be sure to follow the battery disconnection sequence.
Disconnect the ground terminal from the battery with the ignition off.
Remove the center console trim.
Unscrew the bolts of the center console (pic. 3.22).
Unlock and disconnect plug connection 1.
Unscrew bolt 2 and remove holder.
Pull connector 3 out of the holder (pic. 3.23).
Disconnect the plug connections from the electromagnets.
Press the lock lever to the right and pull the switch up and forward from the shift actuator (pic. 3.24).
Installation
Installation is carried out in the reverse order. In doing so, the following must be taken into account.
Lay cables 1-3 as shown in the figure (pic. 3.25).
Fit plug connection 3 in the holder.
Tighten bolt 2.
Connect plug 1 (pic. 3.23). Install the center console trim.
Connect battery.
Install the selector lever.
Visitor comments