Removing
The following sequence of actions must be observed in order not to damage the selector handle.
Remove decorative trim (pic. 3.8).
Pull the handle out of the handle (pic. 3.9).
Pull the button through a certain resistance so that it locks into place.
After that remove the handle from the selector.
Installation
When replacing the handle, never remove the new handle mounting tool.
If the button was accidentally pressed and went inside the handle - hold the handle vertically and carefully blow out the button with compressed air from below until it can be pulled out by hand through a certain resistance.
Reinstall mounting tool A (supplied with handle).
Install the bracket.
Insert the decorative trim into the handle.
Switch the selector to position «N».
I - Carefully slide the bushing through the blinds and the damper below.
Make sure that the bushing is guided very carefully through the protective plates during installation. If the sleeve is pressed inattentively, the protective plates will be destroyed.
II - Push the handle in the longitudinal direction as far as it will go, then turn.
Mounting position: the button is directed towards the driver.
III - Now push the handle onto the selector lever as far as it will go, a click should be heard.
Remove mounting tool A, press the button and pull the bushing up.
Peel off the protective film on the adhesive surface and stick the emblem.
Visitor comments