Removing
Remove the gearshift drive.
Unlock and disconnect the plug.
Unlock the solenoid in the mount and pull up from the outside of the blocking lever 1 and the shift actuator (pic. 3.18).
Installation
Place the solenoid lever 2 vertically upwards.
Install the solenoid at a slight angle into the shift actuator mount.
Connect lever 2 to blocking lever 1 (pic. 3.18).
Push the solenoid all the way into the gearshift actuator until it snaps into place arrow.
Check that the solenoid is fully seated in the mount and that lever 2 is engaged with blocking lever 1 (pic. 3.19).
Visitor comments