Removing
Remove the oil pan.
Remove bolts (pic. 3.71).
Remove the mesh oil filter.
Installation
Install a new gasket 1 on the suction collar of the oil strainer 2 and lubricate it with ATF (pic. 3.72).
M6x70 studs are used as guides for the mesh oil filter.
Screw 3 studs M6x70 by hand into the spool box.
Install the oil strainer onto the studs.
Carefully press the suction collar into the hole on the valve body as far as it will go.
Tighten the oil strainer bolts.
Install the oil pan. After installation, fill in ATF, then check the ATF level if necessary - add oil.
Tightening torques
Oil strainer bolts: 10 Nm.
Visitor comments