Pic. 3.7. Components of the gearshift drive:
1 - selector lever handle; 2 - bracket; 3 - decorative element; 4 - emblem; 5 - bushing; 6 - overlay; 7 - guide plate; 8 - frame; 9 - cable; 10 - selector lock solenoid; 11 - selector lock solenoid in position P; 12 - bolt, 20 Nm; 13 - holder; 14 - holder; 15 - gear shift drive; 16 - bolt; 17 - cover; 18 - lock washer; 19 - selector rod; 20 - lock washer; 21 - support; 22 - bolt, 23 Nm.
ATTENTION: Before starting work with the engine running, set the selector to the position «R» and apply the foot parking brake.
Check of a drive of a gear change
In selector positions «R», «D» and «S» it is forbidden to turn on the starter.
In cars with right-hand steering, it is allowed to turn on the starter in the selector positions «R» and «N» only when the button in the selector lever is not pressed.
When the selector is moved to position «N» at a speed of more than 5 km / h, the selector lock solenoid should not work and block the selector. The selector must freely switch to driving positions.
When the selector switches to position «N» at a speed of less than 5 km/h (the car is practically at a standstill), the selector lock solenoid should only operate after approx. 1 s. Out of position «N» The selector can only be switched with the brake pedal depressed.
Selector in position «R», ignition on
Without pressing the brake pedal, the selector is locked and cannot be switched with the button pressed from the position «R». The selector is blocked by an electromagnet.
When you press the brake pedal, the electromagnet unlocks the selector. The selector can be switched to the driving position. Slowly switch the selector from position «R» into position «S»; at the same time, check the correspondence of the indication of the position of the selector in the instrument cluster with the actual position of the selector.
Selector in position «N», ignition on
Without pressing the brake pedal, the selector is locked and cannot be switched with the button pressed from the position «N». The selector is blocked by an electromagnet.
When you press the brake pedal, the electromagnet unlocks the selector. The selector can be switched to the driving position.
Selector in position «Tiptronic»
The selector is set to the position for operation in Tiptronic mode.
Symbol «D» on the trim of the shift actuator must go out, the symbols must light up «+» and «-».
The indication of the selector position in the instrument cluster when the Tiptronic mode is switched on should change from «P RNDS» on «6 5 4 3 2 1».
Ignition and lighting on
The corresponding symbol on the cover of the gearshift drive lights up.
Selector position indicator
Simultaneous lighting of all segments of the selector position indicator indicates a transmission malfunction.
Check and adjust the selector rod.
Visitor comments