Removal and installation the steering wheel combination switch (VW Transporter T4)

Combination switch

Removal

1. Disconnect the ground (-) cable from the battery.

Attention! This will erase the anti-theft code from the radio receiver's memory. Disconnect the battery only when the ignition is off, otherwise the injection system control unit will fail.

2. Remove the steering wheel.

3. Unscrew the Phillips screws (1) and remove the trim (2).

4. Disconnect the combination switch plugs (4).

5. Unscrew the slotted screws (5) and remove the combination switch from the steering wheel shaft.

6. Remove the upper part of the trim (3).

Installation

1. Install and screw in the push-button switch, connect all plugs.

2. Install the trim.

3. Install the steering wheel.

4. Turn on the ignition and check the operation of the rod switch.