Removing
1. On 1.8-/1.9-/2.3-I engines, remove the control cable support bracket from the transmission.
2. Starting at the back, remove the shift lever boot and move it up the handle (the arrows indicate the place to start removing the protective cover of the gear lever).
3. Release the latch (indicated by an arrow) and remove the shift knob along with the protective cover.
4. Remove the sound insulation at the bottom of the gear lever.
5. Disconnect the front exhaust pipe and middle muffler. Unscrew the exhaust support cross member from the body and lower it down.
6. Unscrew the heat shield under the shift lever.
7. Unscrew nuts of fastening of the lever of a gear change (indicated by arrows).
8. Under the vehicle, unscrew the two bolts securing the shift lever housing.
9. Lower the shift lever housing down and disconnect the cable from it.
Installation
1. Installation is carried out in the reverse order of removal, taking into account the following points.
2. If the seal between the shift lever housing and the body is damaged, it must be replaced.
3. Bolts of fastening of the case of the lever of a gear change tighten the moment of 25 Nm.
4. Install and adjust the position of the exhaust system.
5. Adjust the shift cable.
Visitor comments