Removing
1. Disconnect a wire of weight from the storage battery.
2. Prying off the cover (arrows), remove it from the frame of the center console.
3. Removing the clamp (arrow), remove the cover together with the tip from the gear lever.
4. Remove the acoustic cover, if installed.
5. Remove the front of the center console.
6. Loosen the nuts (arrows) securing the gear shift housing. When installing, tighten to 8 Nm.
7. Remove the air filter housing.
8. Remove lock washers (3 and 4) from gear lever (1) and gear selector (2).
9. Remove the selector and shift cables from their respective levers (arrows).
10. Loosen the bolts (arrows) fastening the support bracket of the drive cables to the gearbox. When installing, tighten to 20 Nm.
11. Remove the noise-insulating casing under the power unit and the cross member of the tunnel.
12. Open the front part of the exhaust system at the place where the double clamp is installed and remove its rear part from the fasteners, remove the front heat shield.
13. Having turned down the case of the mechanism of a gear change, remove it together with driving cables.
Installation
Installation is in the reverse order.
Visitor comments