Order of execution
1. The gearshift lever in its original position must be installed on the 3rd-4th gear engagement line.
2. Press the clutch pedal, start the engine and after 3-6 seconds, test all gears.
3. If gear shifting is not clear, check shift shaft lift as follows.
4. Engage first gear.
5. Press the shift lever to the left, then release the lever and measure the vertical movement of the selector shaft, which should be 1 mm.
6. Loosen the nut to adjust (A) fastening the hinge to the gear pre-selection lever and, moving the cable hinge in the cable slot, set the required shaft movement.
7. Tighten the cable fastening nut to 15 Nm.
8. Reinstall the protective cover of the gear lever.
Visitor comments