- 1 - protective cap
- 2 - cotter pin
Always replace.
- 3 - crown lock washer
- 4 - hex nut
For adjusting the axial clearance of the wheel bearing.
- 5 - pressure washer
- 6 - outer wheel bearing
- 7 - brake drum
The inner diameter, depending on the model, is 200 or 230 mm; the wear limit is 201 or 231 mm, respectively. Permissible lateral runout of the surface of the wheel bolts: 0.2 mm; limit runout of the braking surface: 0.05 mm. Thoroughly clean the brake drum, check for wear, damage, retention of specified dimensions, damage to the threads for the wheel bolts, impeccable condition of the braking surfaces. Fill the wheel hub with universal grease.
- 8 - hex bolt, 60 Nm
- 9 - Belleville spring
The large bearing surface faces the brake shield.
- 10 - brake shield with brake pads
Move the shoes back before removing the brake drum.
- 11 - axle pin
Visitor comments