Violations in the operation of devices and vehicle systems are indicated by control and signal lights, as well as test messages on the display (see illustration), accompanied by an acoustic signal.
Text message on display «STOP Oldruck» (STOP! Oil pressure!) look at the illustrations.
Primary faults are red and minor faults are yellow.
Examples of high priority alerts
Brake system pictogram with warning STOP! BREMSFLUSSIGKEIT BETRIEBSANLE/TUNG (STOP! BRAKE FLUID. See OPERATING MANUAL!)
Coolant pictogram with STOP! KUHLMITTEL PRUFEN BETRIEBSANLE1TUNG! (STOP! CHECK COOLANT LEVEL. See OPERATING MANUAL!)
engine oil pressure pictogram with STOP! OLDRUCK MOTOR ACS BETR1EBSANLE1TUNG! (STOP! ENGINE OIL PRESSURE LOW. STOP ENGINE. See OPERATING MANUAL!)
When there is a malfunction of systems and devices, a certain icon flashes or lights up and three consecutive warning signals sound.
Red pictograms signal danger. Stop and turn off the engine. Check the faulty system or device and correct the problem.
If several critical faults are logged, the icons appear one after the other for approximately two seconds each. The icons flash until the problem is corrected.
It is not possible to switch the display to another mode while the display is showing a high priority warning message.
Minor Warning Examples
engine oil pictogram with message «OLSTAND PRUFEN» (CHECK OIL LEVEL).
Fuel icon with message «WITTE TANKEN!» (PLEASE GO!).
Glass washer pictogram with message «WASCHWASSER AUFFULLEN» (FILL LIQUID INTO WASHER RESERVOIR).
brake pad pictogram with message «BREMSBELAG PRUFEN» (CHECK BRAKE PADS)
Anti-theft icon with message «WEGFAHRSP. AKTIV» (ANTI-THEFT SYSTEM ON)
For minor faults, the corresponding icon will light up and one warning tone will sound. Check the system or device as soon as possible.
If several faults of minor importance are registered, the icons appear one after the other for approximately two seconds each. After a while, the message disappears and an icon remains on the edge of the display as a reminder to check.
Along with warning messages about failures, informational messages about certain processes or reminders of the need to perform certain procedures are displayed.
Visitor comments