1 - cap
2 - nut M8, 20 Nm
3 - washer
4 - lever
5 - windshield wiper drive
6 - frame
7 - Hexagonal nut M6
8 - crank lever
9 - traction
10 - connecting lever
11 - nut M8, 20 Nm
12 - screw M6, 5 Nm
13 - spring washer
14 - washer
15 - rubber ring
16 - O-ring round section
17 - screw M6, 5 Nm
18 - retaining ring
19 - washer
20 - cap
21 - rubber pad
22 - brush
23 - spring locking element
Before removing the wiper arms, mark the position of the blades so that you can reinstall them in the same position. The wiper drive can only be removed after the frame has been removed.
View the original on this portal vwmanual.ru
The crank arm must be removed (1 nut) before the windshield wiper drive is removed. Before installing the drive motor, connect the wiring, let the motor make two revolutions. The motor returns to its original position; the crank arm must be placed on the engine shaft in the original position shown in the figure and secured.
The lower edges of the windshield wiper blades when stationary should be approximately 50 mm from the lower edge of the windshield. Set the blades in the appropriate position. If necessary, rearrange the levers.
Visitor comments