Removal and installation of the left reversing light "X1" or the right reversing light "X2"
The left reversing light "X1" or the right reversing light "X2" are located at the bottom of the rear bumper trim. To remove and install the reversing light or the reversing light bulb, remove the rear bumper trim. Switch off the ignition and all power consumers, remove the ignition key. Remove the rear bumper trim. Unlock and disconnect the plug connector "1". Unclip the wire from its guide "2". Unscrew both mounting bolts "4" and remove the reversing light "3" from the bumper trim.
Installation in reverse order. Tighten the mounting bolts "4" with a torque of 3 Nm. Check the functionality of the reversing light.
Replacing the left reversing light bulb "M16" or the right reversing light bulb "M17"
The information is available on the website (vwmanual.ru)
Instructions: Replacement of the left reversing light bulb "M16" or the right reversing light bulb "M17" is not provided. If it fails, replace the left reversing light "X1" or the right reversing light "X2" as an assembly.
Visitor comments