Removal
Remove the suction pipe.
Remove the coolant pipe.
Fig. 2.169. Oil cooler mounting bolts
Remove the oil cooler (fig. 2.169).
Fig. 2.170. Oil filter holder mounting bolts
The information is posted on this resource [vwmanual.ru]
Unscrew bolts 1..2 and remove the oil filter holder (fig. 2.170).
Installation
Replace the gaskets.
Install the oil separator.
Install the oil filter holder and tighten bolts 1 and 2 evenly to a tightening torque of 15 Nm.
Note: The ground wire for the oil pressure sensor must be secured with bolt 2.
Install the oil cooler.
Further installation and assembly is carried out in the reverse order of removal.
Motor oil
Amount of oil to be poured:
- with oil filter 4.6 l;
- without oil filter 4.1 l.
Fig. 2.171. Markings on the oil dipstick: 1 – Max mark; 2 – Min mark; a – oil level near max mark do not add engine oil; b – oil level in the middle area, engine oil can be added; c – oil level near the min mark, add approximately 0.5 l of engine oil
The oil dipstick is shown in Figure 2.171.
Visitor comments