Note: The illustrations show the left headlight.
Note: Correction of the position of the left headlight is similar to the work on the correction of the right headlight.
Note: If, when checking the position of the headlight after installation, you find uneven gaps between the headlight and the body, it is necessary to correct its position.
Switch off the ignition and all electrical consumers and turn the key to position 0 (pre-stop).
Remove the grille.
Remove the front bumper cover.
Pic. 7.46. Upper headlight mounting bolts
Loosen the headlight mounting bolts (pic. 7.46).
Pic. 7.47. Lower headlight mounting bolts
Loosen the lower headlight mounting bolts (pic. 7.47).
Pic. 7.48. Adjusting sleeve
Match the gaps with the body by unscrewing or tightening the adjusting sleeve at the bottom left or bottom right of the headlight (pic. 7.48).
Tighten all screw connections to the prescribed torque.
Recheck the position of the headlight and adjust the gaps if necessary.
Install the front bumper cover.
Install the grille.
Check the operation of the headlight, including all its functions.
Note: After the headlight has been removed or fitted to the body, it must always be adjusted.
Check the headlight setting and adjust if necessary.
Visitor comments