NOTE: The illustrations show the left headlight. If, when checking the position of the headlight after installation, uneven gaps between the headlight and the body are found, it is necessary to correct its position.
Switch off the ignition and all electrical consumers, remove the ignition key.
Remove the front bumper cover Unscrew the fastening bolts of the guide profile of the bumper cover 1 (pic. 7.92).
Remove the guide profile of the bumper casing 1.
Loosen the two front fixing bolts just enough so that the fixing together with the headlight can move freely in the adjusting sleeves (pic. 7.93).
Adjust the gaps by unscrewing or tightening the adjusting sleeves (pic. 7.94).
Tighten the headlight mounting bolts to the specified torque.
Recheck the position of the headlight and adjust the gaps if necessary.
Install the guide profile of the top bumper panel.
Install the front bumper cover.
Check the operation of the headlight, including all its functions.
NOTE: After installing the headlight or adjusting it to the body, it is always necessary to adjust it. Check headlight setting, adjust if necessary
Visitor comments