Pic. 7.88. Headlight components:
1 - left headlight corrector servo or right headlight corrector servo; 2 - fixing bolts; 3 - cap; 4 - left low beam lamp or right low beam lamp; 5 - left high beam lamp or right high beam lamp; 6 - cap; 7 - cap; 8 - lampholder with a handle; 9 - left parking light lamp or right parking light lamp; 10 - for the left lamp of the front direction indicator or the right lamp of the front direction indicator; 11 - headlight; 12 - adjusting sleeve; 13 - fixing bolts; 14 - headlight mount; 15 - fixing loop; 16 - fixing bolt; 17 - mounting sleeve; 18 - fixing bolts; 19 - plug connection; 20 - locking bracket; 21 - drive shaft for adjusting the turn of the main beam; 22 - drive shaft for adjusting the dipped and main beam in height; 23 - mounting bolts.
NOTE: Check the factors that influence the headlight adjustment, if necessary, adjust the headlights.
NOTE: It is not necessary to disconnect the ground from the battery.
The illustrations show the removal and installation of the left headlight.
Removing
Switch off the ignition and all electrical consumers, remove the ignition key.
Click on the headlight.
Turn the fixing bolt in the direction of the arrow Open (sticker) until resistance is felt (pic. 7.89).
NOTE: Turn the bolt without applying force, otherwise there is a risk of breaking the latch mechanism. The headlight is pushed forward.
Pull the headlight out of the recess in the fender until you feel a stop.
Hold locking clip 1 in the pressed position, remove the headlight from the cutout of the body (pic. 7.90).
Installation
NOTE: The guides must be free of debris. Check that plug 1 is firmly fixed in the headlight holder before inserting the headlight into the guides (pic. 7.91).
Install the headlight into the guides.
Carefully push the headlight into the body cutout.
NOTE: Must be heard «clear» click. This means that the locking bracket is locked.
Turn the fixing bolt in the direction of the arrow Close (sticker) until resistance is felt (pic. 7.89).
Press lightly on the headlight and turn the bolt further in the direction of the Close arrow (sticker).
The retaining clip should click into place with a distinctly audible click.
Check the installation of the headlight for the same side clearances.
If the gaps between the headlight and the body are uneven, it is necessary to correct the position of the headlight.
Check the operation of the headlight, including all its functions.
Check the headlight setting and adjust if necessary.
Visitor comments